Dxr3 - Parameter
Aus VDR Wiki
Version vom 16. Januar 2005, 11:45 Uhr von 84.130.39.217 (Diskussion)
General fixes:
em8300: activate_loopback -- set to 1 if you lose video signal when uploading the microcode bt865_ucode_timeout -- set to 1 if you have a bt865 and get timeouts when uploading the microcode. use_bt865 -- set to 1 if you have a bt865. Modifies some initialization values. This now works with multiple cards, so you can do use_bt865=0,1 if you have two cards and the second uses a bt865.
bt865: rgb_mode -- set to 1 to enable RGB output (requires hacking DXR3 hardware)
color_bars -- set to 1 to enable color bars (only used to test the chip)
If your red and blue colors channels are switched:
adv717x: swap_redblue_pal -- swaps the red and blue channels (ntsc and pal now) pixeldata_adjust_ntsc -- If your red and blue colours are swapped in NTSC, try setting this to 0,1,2 or 3. Defaults to 1. pixeldata_adjust_pal -- If your red and blue colours are swapped in PAL, try setting this to 0,1,2 or 3. Defaults to 1.
Greenscreen (tvout only) fixes:
adv717x: pixelport_16bit -- use 16bit pixelport control pixelport_other_pal -- use the opposite pixelport control for pal mode if you only use/care about NTSC or PAL ignore this
em8300: dicom_fix -- set register 0x1f5e to 0x1efe instead of 0x1afe dicom_control -- set dicom control register to 0x9efe instead of 0x9afe dicom_other_pal -- use the opposite fix values for pal mode if you only use/care about NTSC or PAL ignore this.
Common settings to fix greenscreen:
adv717x pixelport_16bit=1 pixelport_other_pal=1 em8300 dicom_fix=1 dicom_control=1 dicom_other_pal=1
adv717x pixelport_16bit=0 pixelport_other_pal=0 em8300 dicom_fix=1 dicom_control=1 dicom_other_pal=0
adv717x pixelport_16bit=0 pixelport_other_pal=1 em8300 dicom_fix=1 dicom_control=1 dicom_other_pal=1
adv717x pixelport_16bit=1 pixelport_other_pal=0 em8300 dicom_fix=0 dicom_control=0 dicom_other_pal=0